The charger is connected, the battery icon shows a plug, and the tooltip reads “plugged in, not charging.” A Windows 10 laptop battery not charging plugged in leaves the percentage stuck or slowly falling.

The laptop is running from mains power but is not sending any of it to the battery. Sometimes that is deliberate, as part of a battery-care feature.

In other cases, the charger, the battery driver, or the battery itself is at fault. Each http://judolbet88hoki.com/ can be checked at home.

What Might Be Causing It

Charging stops for these reasons:

• A manufacturer battery-protection mode is limiting charge to a set percentage.
• The charger is the wrong wattage, damaged, or poorly connected.
• The battery driver in Windows has a fault.
• The battery is worn out or too hot.

Many laptops stop charging at 60 or 80 percent when a conservation mode is switched on.

Start With These Basic Checks

Check settings and the charger.

1. Open the manufacturer’s utility, such as Lenovo Vantage, MyASUS, Dell Power Manager, or HP’s equivalent, and look for a battery health or conservation mode. Turn it off to test.
2. Inspect the charger cable and plug for damage, and make sure all connections are firm.
3. Plug directly into a wall socket instead of an extension lead.
4. Use the original charger, since a lower-wattage one may power the laptop without charging it.
5. Let the laptop cool if it feels hot, then try again.

A charge limit set by the manufacturer’s software is the most frequently overlooked explanation.

Going a Step Further

Reset the battery driver and power state.

1. Open Device Manager and expand Batteries.
2. Right-click “Microsoft ACPI-Compliant Control Method Battery” and choose Uninstall device. Do not uninstall the AC adapter entry.
3. Shut down, unplug the charger, and hold the power button for 30 seconds.
4. Reconnect the charger and start the laptop. Windows reinstalls the battery driver.
5. Open an administrator Command Prompt, run powercfg /batteryreport, and open the saved file to compare full charge capacity with design capacity.

Update the BIOS from the manufacturer if a newer version mentions charging fixes.

Protect Your Data First

If the battery is swollen, the case is bulging, or the laptop becomes very hot, stop using it and have the battery replaced, as a damaged battery is a fire risk. Use only chargers approved for your model. Perform BIOS updates on mains power.

The Bottom Line

“Plugged in, not charging” is often a charge limit and not a fault. Check the manufacturer’s battery settings first, then the charger, then reinstall the battery driver. A battery report shows whether the battery has simply reached the end of its life.